Filter
Top Products
34
To program a new series of
operations for the buttons which
have already been set
SYSTEM CONTROL 1 or 3 button:
Erase the factory preset program. See
page 38.
Other buttons:
Erase the program. See page 36.
4 Select the component to operate
by pressing the Component Select
button (in this case, TV) or the
Label key.
To change label keys, press the
OTHER button repeatedly until you
obtain the desired component name.
TV
The selected component name is
displayed on the Mode Display key,
and the keys for the selected
component flash.
5 Press the key(s) or button(s) for
the desired operation.
If you want to turn on the TV, press
the POWER key.
Executing a Series of Commands
— System Control Functions
(continued)
You can program the POWER key to
set POWER ON (normal press) and to
set POWER OFF (long press) when
you set a Sony code for the
component.
6 Repeat Steps 4 and 5 and
program the buttons and keys for
the series of operations.
In this example, press the following
buttons and keys.
7 When you have programmed all
the keys and buttons, press
COMMANDER OFF.
COMMANDER
OFF
With a beep sound, a series of
operating commands is registered and
displayed in order. When the display
of keys for the component of which
key you programmed last appears,
the System Control setting finishes.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.