43
To change the component
macro executing time
1 Follow the procedure of Steps 1 -
5 on page 41.
2 Press the TIME key.
The current component macro
executing time stays lit, and (+) and
(–) flash.
3 Press the (+) or (–) key to change
the component macro executing
time. You can control the time
from 0 to 2 sec (seconds) in units
of 1 sec.
Each time you the (+) key is pressed,
the time increased by 1 sec.
Each time you the (–) key is pressed,
the time decreases by 1 sec.
4 Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the previous
setting mode.
