Filter
Top Products
92
Troubleshooting (continued)
Symptom
“NG” flashes five times.
“NG” flashes twice.
“NG” appears during
learning.
Remedy
• Leaning has not succeeded. After checking the follows, try learning
procedure again (page 20).
- Change the distance between remote commanders.
- See “For accurate learning” (page 26).
• The component codes cannot be set. See the supplied “Component
Code Numbers” and try setting the component codes again (page 12).
• The data have not been transferred. See “Transferring data” (page 56)
and try transferring the data again.
• The data has not been received. See “Receiving the data” (page 59) and
try receiving the data again.
• Learned signals have been programmed for the button or key to which
you want to set the learning, System Control or Key Macro function.
Clear the learned signals (page 36, 64) and try setting again.
• Learned signals or the Key Macro function have been programmed for
the Component Select button or the Label key to which you want to
copy the settings of another Component Select button or the Label key
using the copying function (page 48). Clear the contents (page 26, 64)
and try the copying procedure again.
• The key for which you want to program the Key Macro function is not a
Key Macro key. You can program the Key Macro function only for the
Label keys.
• You may try to clear the learned signals in the Key Macro setting mode
(page 64). In this mode, only Key Macro settings can be cleared by
pressing the macro key while keeping the DEL key pressed. To clear the
learned signals, see page 48.
• Learned signals have been programmed for the Label key to which you
want to set the Key Macro function. Clear the learned signals (page 26)
and try setting again. Or set to another Label key.
• There are some keys, for which learned signals have been programmed,
on the display for the Component Select button or the Label key when
the Commander receives the data from another Commander. Clear the
learned signals using the CLEAR key and the RETURN key on the
display of the receiving mode (page 59). Or see “Changing or erasing
the function of a taught key or button” (page 26), and clear the learned
signals.
• The program contents you want to change are set to be executed by the
timer. Set the timer setting in which that program is included not to be
executed (page 69), and edit the program contents.
• You may try to program the Power-On function (page 44) for a
Component Select button or the Label key to which the component code
of a non-Sony product has been set. This function is only for Sony
components.
• You may try to operate the preset function (page 12) after operating the
learning function (page 20). You cannot operate the preset function after
operationg the learning function. Preset after clearing the learned
signals (page 26), or preset to another Component Select button or Label
key that is not used.
• The memory is full. Clear infrequently used learned keys (page 26), then
carry out learning operations.