Filter
Top Products
Chapter 7 Menus
82
7-3 Extended Menu
7-3-2 Extended Menu Operations
The extended menu can be used with the same procedures
as in the basic menu.
However, since with the factory default settings the
extended menu is not displayed, it is first necessary to
enable display of the extended menu.
See 7-2-2 “Basic Menu Operations” (page 74) for more
information about how to select menu items and how to
change their values.
Enabling display of the extended menu
To enable display of the extended menu, an internal switch
must be set to on, and extended menu display must be
enabled in the maintenance menu. (The internal switch is
set to on when the unit is shipped from the factory. Unless
you have set it to off, there is no need to change the switch
setting.)
To set the internal switch to on
1
Using a Phillips screwdriver, remove the bottom
cover.
There are five screws fixing the cover.
2
Using a sharp implement such as a ball-point pen, set
switch 4 in the S1902 group to the ON position (on the
front side).
Note
Do not use a pencil for this operation, as graphite
deposits can cause short circuits and lead to failure.
828 SDI/DV AUDIO OUTPUT SELECT Select the audio signals to assign to SDI and i.LINK(AV/C) audio output
channels.
Sub-item
1 CH1/CH2 tr1/2
: Tracks 1 and 2 assigned to audio output channels 1 and 2.
tr3/4: Tracks 3 and 4 assigned to audio output channels 1 and 2.
tr5/6: Tracks 5 and 6 assigned to audio output channels 1 and 2.
tr7/8: Tracks 7 and 8 assigned to audio output channels 1 and 2.
2 CH3/CH4 tr1/2: Tracks 1 and 2 assigned to audio output channels 3 and 4.
tr3/4
: Tracks 3 and 4 assigned to audio output channels 3 and 4.
tr5/6: Tracks 5 and 6 assigned to audio output channels 3 and 4.
tr7/8: Tracks 7 and 8 assigned to audio output channels 3 and 4.
831 DV OUT AUDIO MODE
Select the audio mode for S400 (i.LINK) connector (output).
4ch: 12 bit/32 kHz/4ch
2ch
: 16 bit/48 kHz/2ch
Menu items in the 800s, relating to audio control
Item number Item name Settings
Menu items in the 900s, relating to digital process
Item number Item name Settings
920 SD-SDI H-ANC CONTROL Select whether or not to add information to the SDI output.
Sub-item
1 AUDIO 5CH-8CH off: Do not add digital audio data channels 5 to 8.
on
: Add digital audio data channels 5 to 8.
2 RP188 ATC off: Do not add RP188 time code data.
on
: Add RP188 time code data.