Filter
Top Products
Operation Instruction
24
LAN Setup
Select between Auto Configuration and Manual
Configuration for network configuration, and
then select the Test button to test the network
configuration you selected.
NOTE: Selecting Auto Configuration allows
the DVR to automatically obtain LAN
parameters (IP address, Gateway, Subnet
Mask and DNS Server address). Selecting
Manual Configuration allows you to set up
LAN parameters manually.
NOTE: The network configuration you set should be tested by selecting Test, otherwise
the Next button will cannot be selected, and you cannot move to the next step.
Use DSL/PPPoE Setup: Selecting the box allows you to set up the DSL network. Entering
the ID and password for DSL connection is required.
NOTE: When the error message “No Device supporting UPnP” displays, check the NAT
device supports the UPnP Port Forwarding function and the function is set to enabled.
DVRNS Setup
Enable DVR Name Service: Select the box
to use the DVR Name Service.
DVRNS Server: Enter the IP address or
domain name of the DVRNS server.
Port: Set the port number of the DVRNS
server.
Enable NAT: Select the box when using the
NAT (Network Address Translation) device.
DVR Name: Enter the DVR name to be
registered on the DVRNS server.
Check: Select the box to check whether or
not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the
DVRNS changes will not be saved.
NOTE: When entering no name or a name already registered on the DVRNS server, an error
message displays.