Speco Technologies CS4 DVR User Manual


 
Operation Instruction
34
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to
the Event mode in the Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the button. You can toggle the entire list
On and Off by highlighting Notification and pressing the
button. You can toggle the individual
items On and Off by highlighting that item and pressing the
button. Highlight OK and press
the
button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification
setup screen and the DVR should be registered in the Speco Central (Remote Administration
System).
Figure 32 Motion Detection Actions 2 setup screen.
Video Loss
Highlight Video Loss in the Event menu and press the button. The Video Loss setup screen
appears.
Highlight the Actions tab, and the Video Loss Actions setup screen appears.
Highlight the desired box under the PTZ
heading, and press the
button. A list of PTZ
presets appear. Select the preset position for
each PTZ camera, where you want PTZ cameras
to move to whenever the DVR detects motion
on the selected camera’s input.
Highlight the desired box under the Digital
Deterrent heading, and press the
button to
toggle between On and Off. When set to On,
the DVR will sound whenever it detects motions
on the selected camera.
Figure 33 Video Loss Settings setup screen.
Highlighting the box under the Video Loss
Interval heading allows you to set the duration
of a signal loss before the DVR will report a
Video Loss. The DVR will not consider any
signal loss from a camera to be a Video Loss
if the detected signal loss is shorter than the
interval set on this screen.