Filter
Top Products
110 Administrator’s Guide SurfControl Web Filter v5.5
W
EB
F
ILTER
S
ETTINGS
Ignored Ports Tab
9
These settings affect how Web Filter monitors users:
• None - If selected, SurfControl monitors users based on workstation name or IP address.
• Enterprise User Monitoring (EUM) - If you have installed EUM, this option will be selected by default.
SurfControl recommends the use of EUM for user name resolution. See the Starter Guide for details
on how to install EUM.
• NetBIOS - Based on the MAC address of the workstation.
• Lifetime of user name - This field is used by NetBIOS only. This determines how often Web Filter
should check each workstation for active users. The default value is 600 seconds.
ENTERPRISE USER MONITORING
If you choose to use EUM after installation, the options in this section enable you to configure how to
monitor user names in a NetWare environment. If you chose to monitor by EUM during installation, the
NetWare Tree and Context details you entered in the Configuration Wizard will be shown, but will not be
editable.
• Preferred Schema - You can monitor by both Windows and NetWare users. You can select your
preferred schema.
• NetWare Monitoring - If monitoring by NetWare user names, you need to enter the following details.
– NetWare Tree and Context - You need to enter your NetWare Tree and Context information in
this field. (For example: OUname.Orgname.Treename).
– NDS tree Username and Password - Web Filter requires a valid NDS tree username and
password to be able to monitor NetWare users. For example: User.OUname.Orgname.
Note: If you install EUM in a NetWare environment, Enterprise User Monitoring is not selected
by default. You need to manually select it.
Note: These settings will only be available if the NetWare client has been installed. SurfControl
recommend installing the NetWare client before installing Web Filter. See Chapter 2 of the
Starter Guide for details.
Caution: Ensure these details are entered correctly, as this information can not be edited
afterwards.