Tektronix 2200 TV Video Accessories User Manual


 
2-25
Switcher Option Module Installation
Switcher Option Module Installation
There are two types of modules. The first type is a full sized circuit board
that slides into the frame bays like a standard module. The second module
type is a smaller “mezzanine” which mounts on a standard circuit board in
the frame.
The installation for each of the Model 2200 options is described below.
Options ordered with the system may already be installed. Most options
also require configuration and/or setup using the soft panel menus. The
menus are given at the end of this section along with explanations for using
each menu.
Empty module cells in the rear bay have blank metal strips screwed in
place to maintain proper air flow inside the switcher and to prevent
electromagnetic interference. These must be removed before the options
can be installed.
CAUTION
Special EMI fingers are installed on each module connector and blank strip in rear
bays. Use extreme care when removing or installing the modules and blank strips
so that the EMI fingers do not break off.