12
EN
Rear Panel
1 ANTENNA IN (DVB-T)
• Connect to an antenna or cable to receive
DVB-T signal.
2 ANTENNA OUT (DVB-T)
• Connect to the Aerial jack on your TV, cable box
or direct broadcast system to output the signal
received at ANTENNA IN (DVB-T). Use the
supplied RF cable.
3 ANTENNA IN (ANALOG)
• Connect to an antenna or cable to receive
analogue signal.
4 ANTENNA OUT (ANALOG)
• Connect to the Aerial jack on your TV, cable box
or direct broadcast system to output the signal
received at ANTENNA IN (ANALOG). Use the
supplied RF cable.
5 COMPONENT VIDEO OUTPUT jacks
• Connect to the component video input jacks on
your TV.
• Use a commercially available Component Video
cable.
6 ANALOG AUDIO OUT jacks
• Connect to the audio input jacks on your TV.
Use a commercially available Audio cable.
7 DIGITAL AUDIO OUTPUT (COAXIAL) jack
• Connect to an amplifier with a digital input jack
such as a Dolby Digital decoder, DTS decoder
or MPEG decoder. Use a commercially
available Coaxial cable.
8 AV2 (DECODER) socket
• Connect to VCR, camcorder, or other
Audio-Video equipment. Use a commercially
available Scart cable.
9 HDMI OUT jack
• Connect to a display with an HDMI compatible
port.
• Use a commercially available HDMI cable.
10 AV1 (TV) socket
• Connect to the Scart socket on your TV. Use a
commercially available Scart cable.
11 Mains cable
• Connect to a standard AC outlet.
Note
• Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage
to the unit.
• This unit does not have an RF modulator.
AV2
(
DECODER
)
AV1
(
TV
)
ANALOG
AUDIO OUT
COMPONENT
VIDEO OUTPUT
ANALOGDVB-T
OUT
IN
ANTENNA
PB/CB
PR/CR
Y
L
R
COAXIAL
DIGITAL AUDIO OUTPUT
PCM/BITSTREAM
HDMI OUT
1 342 5 6 7 9 118 10
E7J70BD_EN.book Page 12 Monday, May 7, 2007 3:31 PM
