Filter
Top Products
EN
72
Set to “ON” to make the dynamic range narrower.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
The Dynamic Range Control function is effective
only with analogue audio connection.
Note
• The Dynamic Range Control function is available
only on discs recorded in the Dolby Digital format.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
48kHz: If your amplifier / decoder is NOT compatible
with 96 kHz PCM, select “48kHz”. Sound
recorded at 96 kHz is down sampled to
48 kHz.
96kHz: If your amplifier / decoder is compatible with
96 kHz PCM, select “96kHz”. Sound is
sampled at 96 kHz.
Note
When playing back a disc with copyright protection:
• Even if you select “96kHz”, the sound is down
sampled to 48 kHz.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
PCM: Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT compatible
with Dolby Digital, set to “PCM”.
Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible with
Dolby Digital, set to “Stream”.
Hint
When playing back a DVD-RW disc recorded in VR
mode:
• If the audio source on a disc is in Dolby Digital
format, set “Dolby Digital” to “PCM” so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT compatible
with MPEG, set to “PCM”.
Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible with
MPEG, set to “Stream”.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
ON: Outputs DTS signals.
If your amplifier / decoder is compatible with
DTS, set to “ON”.
OFF:No DTS signal is output.
If your amplifier / decoder is NOT compatible
with DTS, set to “OFF”.
3. Disc Menu Language (Default: English)
Set the Disc Menu language.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
4. Audio Language (Default: Original)
Set the Audio language.
Select a setting using [U / D], then
press [ENTER/OK].
Your setting is activated.
If “Original” is selected, the audio language is the
default of the inserted disc.
Dynamic Range Control (Default: ON)
PCM sampling (Default: 48kHz)
Dolby Digital conversion (Default: Stream)
Dynamic Range Control
ON
OFF
PCM
48kHz
96kHz
Dolby Digital
PCM
Stream
Settings for MPEG (Default: PCM)
Settings for DTS (Default: ON)
MPEG
PCM
Stream
DTS
ON
OFF
Disc Menu Language
English
Other
Audio Language
Original
English
Other
E7J70BD_EN.book Page 72 Monday, May 7, 2007 3:31 PM