Filter
Top Products
43
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
5 Press [ENTER/OK].
“To Standby Mode” is highlighted.
6 Press [ENTER/OK] again.
In a second, the unit will be turned off
automatically as it goes into the Satellite Link
standby mode.
• Until the time you set in “Start”, the clock will
appear on the front panel display.
• “Sat” will appear on the front panel display at the
start time.
To cancel the Satellite Link function while in the
Satellite Link standby mode:
Press [ ON / STANDBY] to turn on the unit.
To cancel the Satellite Link function while the
Satellite Link Recording is in progress:
Press [S (STOP)] on the front panel of the unit.
Note
• If you have not set the clock, the clock setting
window will appear at step 1. Follow to step 4 in
“Manual Clock Setting” on page 31.
• You cannot set the End time for the Satellite Link
Timer Recording on this unit.
• Recording picture will be distorted if the copy
protection signal is being detected during Satellite
Link Timer Recording.
• When a regular Timer Recording and the Satellite
Link Timer Recording are overlapped, the examples
are given below.
Satellite Link
To Standby Mode
Start
3:00
Mode
XP
Example 1
Example 2
Example 3
Timer
Recording
Satellite Link
Actual
Recording
Timer
Recording
Satellite Link
Actual
Recording
Timer
Recording
Satellite Link
Actual
Recording
E7J70BD_EN.book Page 43 Monday, May 7, 2007 3:31 PM