Filter
Top Products
23
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
Initial Setting
Turn on this unit for the first time, you need to follow
these steps.
1 Press [ ON / STANDBY].
2 Turn the TV on. Select the input to
which the unit is connected.
3 Select your desired channel preset
type using [U / D]. Then press
[ENTER/OK].
The unit will start getting channels available in
your area.
Digital tuning:
Only the DVB channels receivable in your area
are automatically scanned and memorised.
Digital & Analog tuning:
Both analogue and DVB channels receivable in
your area are scanned and memorised
automatically.
Analog tuning:
Only the analogue channels receivable in your
area are automatically scanned and memorised.
4 After finished channel setting,
“Clock Setting” will appear. Then
press [ENTER/OK].
• If you want to adjust the clock, follow to step 4
on page 31 in “Manual Clock Setting”.
5 Press [ENTER/OK] to exit.
Channel Setting
Tuning of this unit to broadcast channels can be
performed in two ways.
Auto Tuning (DVB & ANALOG)
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1 In stop mode, press [SETUP]. Select
“General Setting” using [U / D],
then press [ENTER/OK].
General Setting Menu will appear.
2 Select “Channel” using [U / D], then
press [ENTER/OK].
3 Select “Auto Tuning (DVB &
ANALOG)” using [U / D], then press
[ENTER/OK].
The unit will start storing channels available in
your area.
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
4 Press [SETUP] to exit.
You can select the channels memorised only in
this unit by using [PROG. / ].
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when DVD is in any
recording mode (normal recording, One-touch Timer
Recording or timer recording).
Basic Setup
Initial Setting
Auto Tuning
Make sure the antenna is
connected to “ANTENNA IN” jack.
Digital tuning
Digital & Analog tuning
Analog tuning
Initial Setting
Clock Setting
01 / 01 / 2007 (MON)
10:00
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
Auto Tuning (DVB & ANALOG)
DVB Channel Setup
ANALOG Channel Setup
E7J70BD_EN.book Page 23 Monday, May 7, 2007 3:31 PM