Toshiba D-R17DTKB DVR User Manual


 
41
EN
Introduction Connections Basic Setup Playback
Editing
Others
Function Setup
Recording
Hints for the Timer Recording
If there is a power failure or the unit is unplugged for
more than 30 seconds, the clock setting and all
timer settings will be lost.
If a disc is not inserted or if a inserted disc is not
recordable (finalised DVD-RW/-R, finalised DVD+R,
a fully recorded disc, etc.), flashes and timer
recording cannot be performed. In some cases,
will appear momentarily around the start point as the
unit attempts to record. Please insert a recordable
disc.
When all timer recordings are complete, the
icon flashes. To play back or eject the recorded disc,
press [ ON / STANDBY], and then press
[PLAY P] or [OPEN / CLOSE O].
You cannot make any DVD operation during DVD
timer recording.
If the Start and End times are same, the length of
the recording will be set for 24 hours. If the disc
becomes full during recording, the unit will turn itself
off. To continue recording, press
[ ON / STANDBY] to cancel the timer-standby
mode, insert a recordable disc and press
[ ON / STANDBY] again.
When 2 or more programmes are overlapped,
“Timer program overlapped” appears, and the
overlapped programme will be displayed in blue. To
correct the timer programme refer to “Checking,
Cancelling or Correcting the Timer Programming
Information” on page 40.
If the Start time is earlier and the End time is later
than the current time, the recording will start
immediately after you press [ ON / STANDBY].
Priority of overlapped settings
The unit records programmes according to priority if
the timer programmes overlap.
If the starting time is same:
The timer programming set first (PROG. 1) has
priority.
When the starting time and the ending time for
each programmes are different:
A programme that has earlier start time has priority.
If the recording time is partially overlapped:
The timer programming with the earlier start time
(PROG. 2) has priority. PROG. 1 will start after
PROG. 2 recording is complete.
If the recording time entirely overlaps:
The shorter timer programming (PROG. 1) is not
recorded.
Note for DVD recording
If the recording time of two programmes are
overlapped, or the End time of a programme and the
Start time of another is same, the first 2 minutes (at
the longest) of the subsequent programme will be
cut off.
If the End time of the programme currently being
recorded and the Start time of the subsequent
programme are same:
If PROG. 1 is a DVD recorded programme, the
beginning of PROG. 2 may be cut off.
* If the cut off time exceeds 3 minutes, the error
number “E40” will appear in the Timer Programming
list.
PROG. 1
PROG. 2
PROG. 1 PROG. 2
PROG. 2
recording
will start
after
PROG. 1
recording is
completed.
Actual
recording
The first 2 minutes (at the longest) will be cut off.
PROG. 1
PROG. 2
PROG. 1
PROG. 3
PROG. 2
PROG. 3
Actual
recording
The first 2 minutes (at the longest) will be cut off.
PROG. 1
PROG. 2
PROG. 2 PROG. 1
The first 2 minutes (at the longest) will be cut off.
Actual
recording
PROG. 1
PROG. 2
PROG. 2
Actual
recording
PROG. 1
PROG. 2
PROG. 2PROG. 1
Actual
recording
The first 2 minutes
(at the longest) will be cut off.*
E7J70BD_EN.book Page 41 Monday, May 7, 2007 3:31 PM