Filter
Top Products
24
EN
Auto Tuning (ANALOG)
Programme the tuner to scan only the channels you
can receive in your area.
1 In stop mode, press [SETUP]. Select
“General Setting” using [U / D],
then press [ENTER/OK].
General Setting Menu will appear.
2 Select “Channel” using [U / D], then
press [ENTER/OK].
3 Select “ANALOG Channel Setup”
using [U / D], then press
[ENTER/OK].
4 Select “Auto Tuning” using [U / D],
then press [ENTER/OK].
The unit will start storing channels available in
your area.
Wait for several minutes to finish channel storing.
• Analogue channels will be stored in channel
901-999 after it is scanned by this unit.
5 Press [SETUP] to exit.
You can select only the channels memorised in
this unit by using [PROG. / ].
To cancel auto tuning
Press [RETURN/BACK] or [SETUP] during scanning.
Note
• The selection will be affected by how you receive TV
channels in your local area.
• If the auto tuning is cancelled during scanning,
some channels not yet tuned may not be received.
• You cannot change the channel when DVD is in any
recording mode (normal recording, One-touch Timer
Recording or timer recording).
Manual Tuning (ANALOG)
You can preset an analogue channel manually and
individually.
1 In stop mode, press [SETUP]. Select
“General Setting” using [U / D],
then press [ENTER/OK].
2 Select “Channel” using [U / D], then
press [ENTER/OK].
3 Select “ANALOG Channel Setup”
using [U / D], then press
[ENTER/OK].
4 Select “Manual Tuning” using
[U / D], then press [ENTER/OK].
5 Select “Position” using [U / D], then
press [P].
6 Select the position number you wish
to use using [the Number buttons] or
[U / D], then press [L].
• You can select position number 901-999.
•With [the Number buttons], you only need to
enter the last 2 digit numbers.
7 Select “Channel” using [U / D], then
press [P].
8 Press [U / D] to start scanning.
• The tuner will begin to search up or down
automatically. When a channel is found, the unit
will stop searching and the picture will appear
on the TV screen.
• You can select a desired channel number using
[the Number buttons]. Refer to the following
Channel Plan table and press the three digits to
select the channel number.
(To select channel 4, press [0] first and then
press [0] and [4]. Or press [4] and then “– – 4”
appears and wait for 2 seconds.)
• If this is the channel you want, press [L].
ANALOG
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
Auto Tuning (DVB & ANALOG)
DVB Channel Setup
ANALOG Channel Setup
ANALOG Channel Setup
Auto Tuning
Manual Tuning
Move
ANALOG
Channel Plan
CH Indication TV Channel
01 – 10 IRA-IRJ, GAP
21 – 69 E21 – E69
74 – 78 X, Y, Z, Z+1, Z+2
80 – 99, 100 S1 – S20, GAP
121 – 141 S21 – S41
Manual Tuning
Channel
Decoder
Skip
Position
1
OFF
ON
901
E7J70BD_EN.book Page 24 Monday, May 7, 2007 3:31 PM