Filter
Top Products
6F8A0917
-
10
-
1. Product Inspection and Storage
1.1 Product Inspection
The LF232 electromagnetic flowmeter is shipped in a cardboard box filled with cushioning materials.
Open the package and check the following items:
Are the following items included?
Electromagnetic flowmeter main unit ·························································1 unit
Instruction manual··············································································· 1 copy
Adjusting capacitor ·························1 piece (only for large meter size specification)
Isn’t there any damage to the main unit?
Is the specification the same as when you placed an order?
If you find anything defective and unclear, contact the sales office from which you purchased the
product or your nearest Toshiba representative.
The capacitor attached for large meter size specification can be used to improve the performance when
combining the converter with an old type detector. This capacitor is usually not used. For details, see
5.3.1 “Cautionary Notes on Wiring between Detector and Converter”
1.2 Storage
Regarding the storage after the flowmeter is delivered and before starting installation work, be careful
about the following items:
Do not leave the flowmeter in a place such as outdoors where direct sunlight hits or a place exposed
to rain and wind.
Avoid places where humidity is extremely high or the temperature is extremely high or low and
store the flowmeter in a well ventilated place.
• Humidity range: 10 to 90% RH (no condensation)
• Storage temperature range: -13 to 149 °F (-25 to 65 °C)
Store the flowmeter in a place where vibration and shock does not occur.
If the cover of the converter is left open while being stored, insulation may be deteriorated. Do no
open the cover until the time of wiring for the converter.
To place the flowmeter temporarily on the floor, use a stopper, etc. when needed to prevent it from
rolling over.