Filter
Top Products
6F8A0917
-
112
-
8.3 Initial Settings When Shipped from the Factory
Initial settings used when shipped from the factory unless otherwise specified are shown below.
No. Parameter name Initial setting values
A1 Exciting current
Adjusted value when shipped from the factory
(described on the detector nameplate)
A2 Meter size
Specified meter size when ordered
(described in the Test Record)
A3 Exciting frequency
Recommended value for the detector combined
(See 8.2.3 “Exciting Frequency.”)
A4 Flow direction NORMAL
A5 Password 000
B1 Indicating unit setting (main unit)
m
3
/h (If any range is specified, the same unit as that of
the range)
B2 Indicating unit setting (sub display)
% (If count rate is specified, the same unit as that of the
count rate)
B3 Custom coefficient 0
B4 Custom unit “ ” (7 blank spaces)
C1 Range type
Range type specified when ordered
(If multi-range is not specified, Single range is set)
C2 to 4 Ranges 1 to 4
Values specified when ordered (described in the Test
Record. If not specified, Range 1 is the Toshiba
standard range and Ranges 2 to 4 are zeros)
C5 Hysteresis 3.0 %
Range of 1m/s or more 1.0s
Meter size
16”(400mm) or less
Range of less than 1m/s
Meter size 20” (500mm) or more
3.0s
D1 Damping factor
For partially filled pipes detectors 10s
D2 Low cutoff value 1.0 %
D3 Output when an alarm occurs 4mA output
OFF D4 Display low cut
For partially filled pipes detectors: ON
D5 Output low limit setting 4mA
F1 Digital Output 1 PULSE OUT (Pulse Output)
F2 to 4 Digital Outputs 2 to 4 NO USE (Not used)
F5 to 8 Digital Output 1 to 4 states NORMAL OPEN
G1 to 2 Digital Inputs 1 to 2 NO USE (Not used)
G3 to 4 Digital inputs 1 to 2 detection levels H LEVEL