Filter
Top Products
6 F 3 B 0 3 6 4
145
7.3 When the Module Doesn't Become Run Mode
This section describes on the assumption that the module has started up normally.
Set the parameters of the local station at parameter setting request before issuing an operation
mode control request when you are changing to run mode from standby mode after having started
up the module. Also, clear the scan list before setting slave device parameters at parameter setting
request when the configuration of the slave devices is changed.
(1) Local Node Parameter Setting Request
END
START
Remove the cause of the trouble
based on the completion status.
Check the semaphore area use by
referring to "4.5 The Semaphore Area."
Execute the request by referring to "4.6.3
Parameter Setting Request (local node)".
No
No
Yes
Yes
Is the parameter setting request
completed?
Is the parameter setting request
being executed?
If slave device parameters are unassigned,
go to slave device parameter setting; if they
are already assigned, go to operation mode
control request