Filter
Top Products
87
Chapter 8: Using the TV’s features
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 52/62HMX95
Adjusting the picture (continued)
Using MPEG noise reduction
The MPEG noise reduction feature allows you to reduce visible
interference caused by MPEG compression. Choices for MPEG
noise reduction are High, Medium, Low, and Off. Off is
automatically selected when this feature is disabled (“grayed
out”). This feature is not available in the PC input mode.
To select the MPEG noise reduction level:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. Press y or z to highlight the MPEG Noise Reduction
field, and then press x or • to select either High, Middle,
Low, or Off.
Done
Advanced Picture Settings ANT 1
Dynamic Contrast On
MPEG Noise Reduction
CableClear Auto
Color Temperature Cool
Lamp Mode Low Power
Reset
Low
Color Management
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Using dynamic contrast
When dynamic contrast is set to “On,” the TV will detect
changes in the picture quality that affect the appearance of your
contrast settings and then automatically adjust the video.
When dynamic contrast is set to “Off,” the settings selected in
the Contrast field in Picture Settings will be used.
To select dynamic contrast preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Picture Settings
Advanced Picture Settings
Theater Settings
Video
3. In the Dynamic Contrast field, select either On or Off.
Done
Advanced Picture Settings ANT 1
Dynamic Contrast On
MPEG Noise Reduction
CableClear Auto
Color Temperature Cool
Lamp Mode Low Power
Reset
Low
Color Management
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then set the dynamic contrast to “On,”
the picture mode will automatically change to Preference in the
Picture Settings menu.