Filter
Top Products
Contents Index
Contents
24
Index
24
CONFIGURING CINTIQ FOR HANDEDNESS
During the installation process, you were prompted to choose a default configuration for Cintiq based on
whether you are right- or left-handed. The configuration you chose was used to determine the default
settings for the ExpressKeys and Touch Strips.
However, you can use the Wacom Tablet control panel to easily reconfigure Cintiq for left- or right-handed
users at any time. The ExpressKey and Touch Strip settings are automatically reconfigured when you
change the handedness setting.
USING THE GRIP PEN
The cordless, battery-free pen senses the amount of pressure and tilt you apply to the tip. There are four
basic techniques for using the pen: pointing, clicking, double-clicking, and dragging. If you are unfamiliar
with using the pen, see the following pages.
Holding the pen
Positioning
Clicking
Dragging
Using the side switch
Working with pressure sensitivity
Drawing with tilt
Erasing
To reconfigure for left- or right-handed users:
1. Launch the Wacom Tablet control panel by pressing the center
hardware control button
. Click OPTIONS....
2. Choose the appropriate setting for your preferred handedness.
3. Click OK. The existing ExpressKey and Touch Strip settings are
swapped (or flipped) between left and right.
Notes:
The hardware control buttons are not affected when you
change the handedness setting.
Likewise, changing the handedness setting does not affect the
ExpressKeys used to control the LCD settings when in LCD
settings (OSD) mode.
This procedure does not affect the default orientation. At the
system log on and user switching screens, the pen display uses
the default configuration you chose during the install process.
To change the default configuration, you must re-install the
Wacom driver.