Filter
Top Products
Contents Index
Contents
94
Index
94
CABLE REMOVAL AND REPLACEMENT
If you should need to remove or replace a Cintiq cable, follow the below procedure.
Remove a cable
:
1. Turn off your computer and power off Cintiq. Disconnect all cables from between the pen display and
your computer.
2. Remove Cintiq from the display stand
. Place the pen display face down on a flat, soft surface (such as
a cloth spread across a desktop).
3. Remove the bearing hub by unscrewing the four bearing hub attachment screws. Carefully separate
the bearing halves and remove the bearing stopper to free up the cabling. For details, refer to the
instructions found in using an alternate mount or stand
.
4. Loosen the rear cover screws and lift the cover away from the pen display.
5. Remove the cable clip and unseat the cable.
6. If the cable you wish to remove has thumbscrews, loosen them. Disconnect and remove the cable.
Connectors are DVI-I, USB,
and power.
Cable clip
Cable seats