Filter
Top Products
10 78-8130-6150-0 Rev G
The Battery Icon [8] on the Locating Displays will continuously indicate the battery
level.
C. Cleaning
Use a soft damp cloth to clean the product and test leads if necessary.
D. Service and Accessories
Information regarding service, accessories, or replacement parts can be obtained by
contacting 3M at 1-800-426-8688.
This equipment does not require annual calibration or maintenance.
E. 3M
™
Dynatel
™
Transmitter 2250 Keypad and Connector Definitions
Trace
Output Level
Dynatel
TM
2250
+
-
o
off on
T-1 T-2 T-3 T-5 T-6 T-7
[T-1] off: Turns unit off and performs battery test.
[T-2] on: Ohm-meter / Tone: Turns the unit on and cycles through the following
commands when pressed repeatedly.
Ohm-meter: Measures the continuity of the trace conductor/pipe and its far-end
ground. It is also used to measure the fault resistance to earth.
Tone: In the tone mode, the transmitter generates 577 Hz and 200 kHz signals.
[T-3] on: Trace (frequency): Turns the unit on and places the unit in Trace mode.
Select Frequency: Press Trace [T-3] repeatedly to cycle through the transmitter’s
active frequencies (577 Hz, 8 kHz, 33 kHz, and 200 kHz). The selected frequency
will be displayed [T-4]. ‘ALL' indicates that the following active frequencies are
transmitting simultaneously: 577 Hz, 8 kHz, 33 kHz, and 200 kHz.
[T-4] Digital Display:
Indicator Flags: These flags coincide with the operational mode of the transmitter.
(From top left to bottom right) Trace mode [T-3], Tone mode [T-2], Ohm-meter [T-2],
Voltage (at start up the transmitter checks for foreign voltage), and the Output Level
Flag (no flag = normal output; flag = high output; flashing flag = maximum output).
Digital Display: Indicates frequency, relative current, resistance, battery level and
voltage (if present on target).
[T-5] Output Level: Cycles output level; normal, high and maximum.
Normal=No Flag; High=Flag; Maximum=Flashing Flag (indicated in Digital Display
[T-4])
NOTE: An external 12-volt power source is required to obtain Max Output level (12
watts for 12-watt transmitters and 5 watts for 5-watt transmitters).