Filter
Top Products
78-8130-6150-0 Rev G 41
D. Dual Marker Locate
1. Press Locate/OK [5].
2. Press Marker [SK].
3. Press MARKR 1 [SK Toggle] to select desired
utility.
4. Press MARKR 2 [SK Toggle] to select desired
utility.
Note: Only the marker types enabled in the setup menu will be shown. (See Enabling/
Disabling Marker types, Section 13A). When scanning for markers, the gain level [4]
should be set high.
− The third and fourth soft key commands will populate with the types of utilities
selected for Marker 1 and Marker 2.
5. Adjust the Gain [4] down until the bar graphs open.
− The bar graph will close, the audio will increase, and the Signal Strength [10]
will increase when the receiver detects a marker of the specified utility.
− When one of the two markers is detected, press the “XXX Only” [SK] for the
detected utility marker. ("XXX" represents the marker types selected. In the
above example, PWR Only and TEL Only.)
− The receiver will switch to Single Marker Locate in order to pinpoint the
marker.
6. Press Markr 2 [SK Toggle] to return to Dual Marker Locate.
E. 3M
™
iD Marker Depth
1. Lower the tip of the receiver to the ground over the pinpointed marker.
2. Press Depth [SK].
− The receiver will examine the marker
(Calculating, please wait...)
− If the marker is a 3M
™
iD Marker, the
receiver will display the depth of the
marker, and its identification serial
number.