Filter
Top Products
42 78-8130-6150-0 Rev G
3. To save the depth reading, press Mem Select
[SK].
− Five depth readings can be saved with the
time, date, and its identification number.
− Save [SK] will place each entry in
sequential order in memory (M1 - M5)
until five readings have been stored. The
receiver will overwrite saved entries in
excess of five, beginning with M1.
4. Optional: Press Clear All [SK] to delete all stored depth information.
5. Press Mem Select [SK] to select a specific memory location (M1–M5) to store the
depth readings. When the preferred location appears on the display, press Save
[SK]. The display and memory location will populate with the current information.
6. Each memory location can be reviewed by pressing Mem Select [SK].
7. Press Locate/OK [5] to return to Marker Locate Mode.
F. Passive 3M
™
Electronic Marker (Non-iD) Depth
1. Lower the tip of the receiver to the ground over the pinpointed marker.
2. Press Depth [SK].
− The receiver will examine the targeted marker.
− The display will instruct the operator to raise the unit 6 inches (15.2 cm) from
the ground.
Note: This 6-inch (15.2 cm) rise must be exact for the depth reading to be accurate.
A suggestion is to utilize a 6 inch (15.2 cm) piece of plastic pipe or wood as a spacer
between the ground and the tip of the receiver for this precise measurement.
3. Raise the receiver 6 inches (15.2 cm). Press the
Depth [SK] key again. The estimated depth of
the marker from ground level will be displayed.
− Five depth readings can be saved with the
time and date.
4. To access the memory locations, press Mem
Select [SK].
− Save [SK] will place each entry in sequential
order in memory (M1–M5) until five
readings have been stored. The receiver will
overwrite saved entries in excess of five,
beginning with M1.
5. Optional: Press Clear All [SK] to delete all stored depth information.