Filter
Top Products
20 78-8130-6150-0 Rev G
To program the user defined frequencies press the
right arrow [SK] to highlight the Auxiliary group
of frequencies. Press the up/down arrows [SK]
to highlight the user frequency to program. Press
Enabl/Disabl [SK].
Press the left/right arrows [SK] to move the square
cursor to a digit. Press Select [SK] to enter the
number in the frequency field.
Press Locate/OK [5] to save the programmed
frequency, or press Exit [SK] to cancel. The
frequency will appear in the locate frequency
display as U ###, where ### represents the selected
frequency.
Note: To redefine a previously programmed user
frequency, highlight the frequency, press enabl/
disabl, select the back arrow with the cursor, and
press select to delete the previous entry.
G. Filtering Power Frequency Interference
MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + >>More [SK:6h] + Filter[SK:6k]
In order to filter out unwanted power influences
while locating with user-defined frequencies, verify
the correct frequency is selected for your location
(default is 60 Hz). Press Locate/OK [5].
H. Selecting Locating Audio
MENU [6] + >>More [SK:4] + Setup [SK:6] + >>More [SK:6d] + >>More [SK:6h] +
AudioConfig [SK:6l]
The user can choose the audio response of the
receiver when using the Directional Peak mode for
path locating. Highlight the audio selection and press
Locate/OK [5] to save.