Filter
Top Products
62 Chapter 1
Instrument Messages
Instrument Messages
Instrument Messages
10238 RF Board SR Osc Unlocked. Contact service center.
This message occurs if the sample rate (SR) oscillator on Option B7E is in
an unlocked state. This indicates broken hardware.
10239 Opt Freq Ref setting does not match external reference.
This message is generated if Source is set to External on the properties
form under the front-panel
Mode Setup key and the frequency on the same
form is set to a frequency that does not match the frequency of the signal
being used as the external reference.
10240 RF Board RF Osc Unlocked. Contact service center.
This message occurs if the reference oscillator on the (Option B7E) is in an
unlocked state. This indicates broken hardware.
10241 RF Board could not detect any bursts in signal.
This message is generated when the trigger is set to RF Burst and (Option
B7E) cannot detect a burst.
10245 Error reading file: SPCLIMIT.CSV. Cannot use custom limits.
The file could be missing or corrupt. Create a new limits file. Alternatively,
the actual limits defined in the file might not allow the measurement to be
executed. Redefine the limits or use the default limits. Restart the
measurement.
10246 Error reading file: CDMASTUN.CSV. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10247 Error reading file: CDPDMDA. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10248 Error reading file: CDPPMCO. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10249 Error reading file: CDPPMDA. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10250 Error reading file: RHODMDA. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10251 Error reading file: RHOPMCO. Please reinstall cdmaOne.
The file is missing or corrupt. Please reinstall the cdmaOne personality.
10256 Error reading file: OOBSTAB.CSV. Use Edit Table
| Save Table.
This error is generated when you try to load a table (using the
Load Table
key on page 2 of the edit table form menu) before a table has been saved.
You must first save a table using the
Save Table key before trying to load a
table using the
Load Table key.