Filter
Top Products
82 Chapter 1
Instrument Messages
Instrument Messages
Instrument Messages
Error Awaiting valid signal.
This indicates that software enhanced triggering is ON and 5 successive
failures have been detected within a demod measurement
Error Signal frequency malformed. Signal not added.
Error Unable to retrieve signal (remote).
EMC message NOT USED
Error Unable to uninstall personality, file not deletable.
This message occurs when you try to delete a personality which has been
marked as non-deletable. The personality is marked non-deletable at the
factory. Get in touch with your nearest service center for further
assistance.
Informational Messages
These messages simply provide information; you are not required to do anything.
Information in brackets (such as <directoryname>), is a previously-provided input.
Informational messages appear at the bottom of the screen in the status line.
Informational <directoryname> directory deleted
The directory indicated has been successfully deleted.
Informational <directoryname> directory deleted
The directory indicated has been successfully deleted.
Informational <name1> <directoryname1> directory renamed to <name2>
<directoryname2>
Directory name1 has been successfully renamed to directory name2.
Informational <filename> file copied
The filename indicated has been successfully copied.
Informational <filename> file deleted
The filename indicated has been successfully deleted.
Informational <filename> file loaded
The filename indicated has been successfully loaded.
Informational <filename> file saved
The filename indicated has been successfully saved.
Informational <filename> too many data entries
This message may appear when loading data from a limit line or ampcor
disk file. The [DATA] section of such a file can contain at most 200 lines of
data. This message is displayed if that limit is exceeded.