Filter
Top Products
84 Chapter 1
Instrument Messages
Instrument Messages
Instrument Messages
Informational Device = Mobile. Code Domain not available.
Code Domain measurement is grayed out when the device is set to mobile
under the
Mode Setup front-panel key. Code Domain measurement is only
accessible when the device is set to base and RF Communications
Hardware (Option B7E) or Enhanced Memory Upgrade (Option B72) are
installed.
Informational Directory already exists
Each directory and file must have a unique name. The directory name you
have entered is currently being used on the selected drive. You may either
enter a new name or rename the directory currently existent.
Informational Device = Mobile. Mod Acc not available.
Modulation accuracy measurement is grayed out when the device is set to
mobile under
Mode Setup, front-panel key. Modulation accuracy is only
accessible when the device is set to base and RF Communications
Hardware (Option B7E) or Enhanced Memory Upgrade (Option B72) are
installed.
Informational Directory already exists
Each directory and file must have a unique name. The directory name you
have entered is currently being used on the selected drive. You may either
enter a new name or rename the directory currently existent. Refer to “File
Menu Functions” in the Agilent ESA Spectrum Analyzer User’s Guide.
Informational ENR table will be extrapolated
One or more calibration or measurement frequency points exceeds the
currently loaded Cal or Meas ENR Table frequency ranges. The
corresponding ENR tables lowest frequency ENR value will be re-used for
frequencies less than the table range, and the highest frequency ENR
value will be re-used for frequencies greater than the table range.
Informational Entire trace is below the threshold level.
The measurement cannot operate properly because the trace has fallen
completely below the threshold level. Change the threshold level to view
signal.
Informational Invalid format: CSV files are not supported by this
measurement.
When utilizing the Phase Noise Personality: Option 226, the *.CSV file
format is not available.
Informational Invalid EDGE burst timing.
The burst has manually been positioned off the display.