ARRI WRC-1 Universal Remote User Manual


 
125
In the user mode, all adjustments are not
carried out linearly within the adjustment time,
as in the other WRC modes. For this reason,
ramp durations may be different, compared to
those in the other WRC modes.
The first line of the main menu shows the currently adjusted
shutter angle (if controlled by the WRC-1).
If the iris is controlled by the WRC-1, this is indicated by
an F at the end of the first display line. By pressing the
SET button, the currently adjusted aperture can be shown
in the first display.
The second line shows the currently adjusted camera speed.
Note: The display shows full T-stops followed by the
tenth of a T-stop. Example: T-stop 2.8 plus half a
T-stop is shown as 2.8_5. The tenths of a T-stop
are linearly divided between the two full T-stop
positions.
Note The following warnings may be displayed:
IRIS TBL a valid iris table has not yet been
activated;
readings with NO in the first display line
indicate that the selected function is currently
not available (example: NO IRIS although the
iris control is activated on the WRC-1, the iris
motor has not yet been connected);
readings with RANGE in the second display
line indicate that the adjustment range of a
parameter has been exceeded (example: the
selected speed is not available with this camera);
readings with OFF in the first display line
indicate that this function is deactivated on the
camera (example: shutter angle of the 435 is
set manually = OFF ANGLE).
Correct parameters must be set before the
camera is started!
user mode
Controlling the Camera Speed