ARRI WRC-1 Universal Remote User Manual


 
45
Press the CAL button on the WMU-1 to start the
calibration process before entering any values.
Turn the handwheel until TBL EDIT is displayed.
Press the SEL button to go to the input mode.
Turn the handwheel to the left until the first T-stop of
the iris ring of the lens being used is shown in the
second line of the display.
This must be a full T-stop from the standard T-stop
range.
Then press the SEL button. ADJ now flashes in the
first line of the display.
Adjust the iris ring of the lens to the displayed value
using the handwheel.
The T-stop is assigned by pressing the SET button. This
is indicated in the first line with an I next to TBL.
In case you need to delete this assignment, press the
SET button again. The I next to TBL disappears again.
Turn the handwheel until the next T-stop on the iris ring
of the lens being used is shown on the display. Assign
this and the next T-stops as described above.
Controlling the Iris