ARRI WRC-1 Universal Remote User Manual


 
24
4.2 WRC-1 in cable mode
Connected with a cable to the camera only those fuctions of
the WRC-1 are available which relate to the camera speed
and the shutter angle. The iris of the lens cannot be controlled
in the cable mode because the iris motor cannot be accessed.
Required system components:
WRC-1 .................................................... K2.52087.0
WC-W1-S cable ....................................... K2.52089.0
WHA-1.................................................... K2.52070.0
4.2.1 Mounting the WRC-1 on the
Wireless Handgrip Attachment
(WHA-1)
If a control unit is already attached remove it by
pressing the release button. Swing out the unit and
then remove it by pulling it upwards.
Insert the WRC-1 into the available free space on the
WHA-1 (Wireless Handgrip Attachment) with the
wide black pin pointing forward photo. Then
press the WRC-1 onto the WHA-1 until the module
audibly snaps into position.
Connect the WHA-1 to the CCU socket of the camera
using the WC-W1-S cable.
RELEASE button
black pin
WHA-1
Setup
WC-W1
WRC-1