ARRI WRC-1 Universal Remote User Manual


 
177
7.3.2 Entering values
The main menu is indicated by a black bar photo in
the top right corner of the display. The currently adjusted
value and the value of one of the two possible exposure
compensation options are shown in the display.
If PROG is also shown, a time-controlled ramp function
(ramp Iris, ramp
)
, ramp fps) has been selected using the
WRC rotary switch. In this case, the handwheel is without
function in the main menu.
In the three other WRC rotary switch positions (fps,
)
, iris)
a parameter can be adjusted manually using the handwheel.
The display shows the adjusted value and an automatically
calculated and adjusted compensation value.
Press the MODE button to go to the first submenu to
define the end-stops of the handwheel or the limit values
of the master value of a ramp.
Press the MODE button again to go to the next submenu.
Press the SEL button for longer than 2 seconds in order
to activate the input mode in a submenu.
The adjustable digits flash.
These can now be set by turning the handwheel.
Press the SEL button again to activate the next digits.
This procedure is repeated until all the positions have
been set. The first digits are confirmed, and the decimal
positions are set to 0, by pressing the SET button.
The end-stops of the handwheel or the limit values of the
master value of a ramp are always defined in the first
submenu
i.e. selected master value: camera speed the limit values
for the camera speed are defined in the first submenu.
The remaining exposure-related parameters are defined
in the following submenus, if the corresponding functions
are controlled by the WRC-1.
black indicator bar for main menu
Quick Guide