Filter
Top Products
42
•‘ADJ’ now flashes in the first line of the display.
A T-stop value is shown in the second line.
• Adjust the iris ring to the displayed value using the
handwheel.
• The T-stop is assigned by pressing the SET button.
This is indicated in the first line with an ‘I’ next to ‘TBL’.
This defines the entire iris table.
‘DONE’ is shown on the display for one second.
• The display then shows ‘TBL’ in the first line,
and the letter ‘F’ and a T-stop value in the second line.
The individual T-stops available for this lens must now
be checked using the handwheel!
An ‘I’ is shown in the first line of the display next to
‘TBL’ for every T-stop programmed for this lens.
Note: Only full T-stops are accessible for checking to
speed up the process in this mode.
After loading the iris table, all individual T-stops
on the lens must be checked by adjusting with
the handwheel in order to avoid incorrect
exposures!
Controlling the Iris