Filter
Top Products
71
In the user mode, all adjustments are not
carried out linearly within the adjustment time,
as in the other WRC modes. For this reason,
ramp durations may be different, compared to
those in the other WRC modes.
The main menu shows the symbol ’
)
’ in the first line of the
display for adjusting the shutter angle (if controlled by the
WRC-1) and the currently adjusted T-stop. The currently ad-
justed mirror shutter angle (if controlled by the WRC-1) can
be shown in the first display line by pressing the SET button.
The currently adjusted camera speed is displayed in the
second line.
The display shows full T-stops followed by the tenth of a
T-stop. Example: T-stop 2.8 plus half a T-stop is shown as
2.8_5. The tenths of a T-stop are linearly divided between
the two full T-stop positions.
The ‘PROG’ symbol indicates that a time-controlled ramp
function has been selected.
Note The following warnings may be displayed:
‘IRIS TBL’ – a valid iris table has not yet been
activated;
readings with ‘NO’ in the first display line
indicate that the selected function is currently
not available (example: ‘NO IRIS’ although the
iris control is activated on the WRC-1, the iris
motor has not yet been connected);
readings with ‘RANGE’ in the second display
line indicate that the adjustment range of a
parameter has been exceeded (example: the
selected speed is not available with this camera);
readings with ‘OFF’ in the first display line
indicate that this function is deactivated on the
camera (example: shutter angle of the 435 is
set manually = ‘OFF ANGLE’).
Correct parameters must be set before the
camera is started!
user mode
Controlling the Iris