Filter
Top Products
Contents
13
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
SNMP Community Strings 18-4
Using SNMP to Access MIB Variables 18-4
Configuring SNMP 18-5
Default SNMP Configuration 18-5
Enabling the SNMP Agent 18-5
Configuring Community Strings 18-6
Specifying SNMP-Server Group Names 18-7
Configuring SNMP-Server Hosts 18-8
Configuring SNMP-Server Users 18-8
Configuring Trap Managers and Enabling Traps 18-8
Setting the Agent Contact and Location Information 18-10
Using the snmp-server view Command 18-10
SNMP Examples 18-10
Displaying SNMP Status 18-12
CHAPTER
19 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode 19-1
Understanding Repeater Access Points 19-2
Configuring a Repeater Access Point 19-3
Default Configuration 19-4
Guidelines for Repeaters 19-4
Setting Up a Repeater 19-5
Aligning Antennas 19-6
Verifying Repeater Operation 19-7
Setting Up a Repeater As a LEAP Client 19-7
Setting Up a Repeater As a WPA Client 19-8
Understanding Hot Standby 19-9
Configuring a Hot Standby Access Point 19-10
Verifying Standby Operation 19-12
Understanding Workgroup Bridge Mode 19-13
Treating Workgroup Bridges as Infrastructure Devices or as Client Devices 19-15
Configuring a Workgroup Bridge for Roaming 19-16
Configuring a Workgroup Bridge for Limited Channel Scanning 19-16
Configuring the Limited Channel Set 19-16
Ignoring the CCX Neighbor List 19-17
Configuring a Client VLAN 19-17
Workgroup Bridge VLAN Tagging 19-17
Configuring Workgroup Bridge Mode 19-18
Using Workgroup Bridges in a Lightweight Environment 19-20