Filter
Top Products
18-7
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-29225-01
Chapter 18 Configuring SNMP
Configuring SNMP
To disable access for an SNMP community, set the community string for that community to the null
string (do not enter a value for the community string). To remove a specific community string, use the
no snmp-server community string global configuration command.
This example shows how to assign the strings open and ieee to SNMP, to allow read-write access for
both, and to specify that open is the community string for queries on non-IEEE802dot11-MIB objects
and ieee is the community string for queries on IEEE802dot11-mib objects:
ap(config)# snmp-server view dot11view ieee802dot11 included
ap(config)# snmp-server community open
rw
ap(config)# snmp-server community ieee view ieee802dot11 rw
Specifying SNMP-Server Group Names
To configure a new SNMP group, or a table that maps SNMP users to SNMP views, use the following
command in global configuration mode:
Step 3
access-list access-list-number
{deny | permit} source [source-wildcard]
(Optional) If you specified an IP standard access list number in
Step 2, then create the list, repeating the command as many times
as necessary.
• For access-list-number, enter the access list number specified
in Step 2.
• The deny keyword denies access if the conditions are
matched. The permit keyword permits access if the conditions
are matched.
• For source, enter the IP address of the SNMP managers that
are permitted to use the community string to gain access to the
agent.
• (Optional) For source-wildcard, enter the wildcard bits in
dotted decimal notation to be applied to the source. Place ones
in the bit positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
snmp-server group [groupname {v1 | v2c | v3 [auth | noauth
| priv]}][read readview] [write writeview] [notify notifyview]
[access access-list]
Configures a new SNMP group, or a table that maps SNMP
users to SNMP views.