Dish Network Solo 508 Satellite TV System User Manual


 
Chapter 3
Page 48
Using the System
When You’ve Locked the Receiver
If you try to watch a locked channel or program, erase a protected
DishDVR recording, or open the
Locks m enu, the receiver displays a
message that tells you to enter the password.
The rec eiver gives you three tries to e nter the right password. If you
can’t do this, the re ceiver doesn’t let you try again for several minutes.
If you e nter the right password, you can watch a locked channel or
program or ope n the
Locks menu.
If you leave a locked channel or program or the
Locks m enu, you must
enter the password again to see the channel, program, or
Locks menu
again.
If you unlock the receive r, leave the locks unchanged, and then lock the
receiver again, you a pply the same locks as before.
Personal Identification Number
You can set up a Personal Identification Num ber (PIN) for call-in requests
only. Anyone who calls the Customer Service Center must provide this PIN
to make any changes to your account, to buy services, or to get inform ation.
You can c all the Custome r Service C enter at 1-800-333-DISH (3474) at any
time to set up a PIN.
If you forget your PIN, you must call the Custome r Service Center. We may
ask for more information to make sure it’s oka y for you to make changes to
your account.
Use Ev en t Timers
Many satellite TV programs a nd film s a re copyrighted. In some
cases, copyright law may apply to private, in-home recording.
Event timers let you set up the receiver to tune in future programs and/or
record them, with the DishDVR features or a VCR.
An “event” is a program, sports event, pay per view movie, or anything
else on satellite TV.
You can quickly set a one-time event timer with Quick Re cord.See
page 50.
You can set an automatic event timer fo r a program listed with start and
stop times in the
Program Guide. This can be a program that comes on
each day or each week. See page 51.
•Amanual event timer lets you set custom start and stop times for a
timer. You can use a manual timer to record part of a program, several
programs together, or parts of several programs. See page 52.