Filter
Top Products
Page 93
Installing a DISH 500 Antenna
10. Press CAN CEL to exit bac k to the Point Dish/Signal menu.
11. Point the dish for the strongest possible signal, following the instructions
that came with it and the DishPro wiring diagrams that start on page 94.
12. Connect any switches in your system, using the instructions which came
with the switch(es).
13. Se lect Check Switch fr om the Point Dish/Signal menu. When the
Check Sw itch menu opens, select Check or Test. When the procedure
complete s, you will see the Installation Summary scree n again. This
time you should see confirmation for all sate llite s your dishes are pointed at,
and “Satellite reception verified.” You should also se e that the switc h(es) in
your system has been correctly identified.
Refer to the DishPro wiring diagrams for examples of installation summary
screens.
14. Press CAN CEL to exit this me nu, and then Ca ncel to exit the Point
Dish/Signal screen.
If you have any other receivers in your system, make sure you run Check
Switch on each of them, a nd allow each to take the software upgrade, as
needed.