Filter
Top Products
RASFinder RF300E/RF310E User Guide
RF300E/RF310E20
8 The software is loaded onto your pc, then the Setup Complete dialog box is displayed.
Click Finish to continue.
9 The following message appears:
10 Click Yes to download wizard setup. Clicking No prevents you from setting up the defaults and
downloading them to the RASFinder; instead, you are returned to the program group.
11 The Default Parameters dialog box appears. This dialog box enables you to assign the router name
(required for IPX routing), establish the IP address, mask, and default route for the LAN port, enable
or disable IPX routing, set up the remote addresses for the WAN ports, and disable any WAN ports
not used.
Router Name: If this is the only RASFinder on your network, you can use the default Router Name
(MTROUTER); otherwise, you must assign a new Router Name in this field. The Router Name can
be any printable ASCII string of up to 8 characters. The RASFinder will use this name to advertise its
service in the IPX internetwork.
The default LAN IP Address has to be changed to your unique LAN port address. In the LAN group,
change the default Address to the value assigned to your LAN port. When you change the LAN
Address, the remote WAN addresses also change to the same network and in sequential order.
Change the default Mask to the value assigned to your LAN port.
If you established a Default Route on your LAN, enter the address of the route.