Filter
Top Products
Chapter 6 - RAS Dial-out Redirector
RF300E/RF310E 95
8. The files are loaded onto your system and then the COM Port to MCSI Mapping widow is
displayed.
Note: If the IP option is selected, you will need to make a change to the ROUCON.INI file.
Before making the change, make certain that the RASFinder software has been installed and
is running. From a DOS prompt, change the directory location of the RASFinder 3.10
software and then edit the ROUCON.INI by changing the line” AG Network Interface To Use
= 0” to “AG Network Interface To Use = 1”. Once you’ve done this, save and download the
changes.
Click Add Port to add a port to the Local Port list box.
If you want a specific line, click a COM port in the Local Port list box, then click the line to which
you want to map that particular COM Port. The status message "Mapped to MCSI" should
appear above the Local Port list box.
Click Remove Port to permanently remove a port from the Local Port list box.
Click the Unmap button if you want to unmap a line.
Click the Search button to search for lines on a server.
Click the Close button when finished.
At this time Your WINMCSI software installation is complete. Proceed to the next section,
“Running the WINMCSI Workstation Software.”