Panasonic AG-DV2000P VCR User Manual


 
Power Save Mode
1
Press
MENU,
and then select
OPTION SETUP1.
On Screen Display
Wide Mode
1
Press
MENU,
and then select
OPTION SETUP1.
2 Select WIDE MODE.
2
Select
POWER SAVE MODE.
3
Select
OFF
or
S1.
3
Select
OFF, 2H
or
6H.
OFF:
When the S-Video input socket on the monitor
that is connected is an S-Video socket.
S1:
When the S-Video input socket on the monitor
OFF:
This setting does not conserve power when the
that is connected is an S1 -Video socket.
VCR is off.
(If a wide mode video signal is sent to the
2H:
The VCR turns off automatically if no operation is
monitor, the monitor screen size will automatically
performed for approximately two hours.
switch to wide mode.)
6H:
The VCR turns off automatically if no operation is
performed for approximately six hours.
4
Press
MENU
twice to exit the On Screen Display.
4
Press
MENU
twice to exit the On Screen Display.
To Set the Remote mode
1
Press
MENU,
and then select
OPTION SETUP1.
2 Select REMOTE MODE.
3
Select
VCR1, VCR2
or
VCR3.
This allows the remote controller to be set for operating
VCR1, VCR2 or VCRS.
When changing the remote control mode, press
VCR1 ,VCR2
or
VCR3
while holding down
POWER
to change the remote control mode of the remote
controller. If this is not done, it will not be possible to
operate the VCR using the remote controller.
4
Press MENU twice to exit the On Screen Display.
20