Filter
Top Products
Search for the edit start point on the
playback unit using Jog dial and Shuttle
Ring on this unit.
Press JOG/SHUTTLE on this unit.
Editing begins.
To continue editing, press
JOG/SHUTTLE
on this VCR, and repeat steps
4-5.
Press
(STOP)
on this unit to stop
editing.
To monitor the edited audio after Audio
Dubbing
Press
STEREO SELECT
during playback and select
STEREO2.
Notes:
Video Insert and Audio Insert are not possible in the
following cases:
When the tape in the recording VCR (this unit) is:
Recorded in LP mode;
Blank, or contains a blank portion in the middle.
AV Insert and Audio Dubbing are not possible in the
following cases:
When the tape in the recording VCR (this unit) is:
Recorded in 16bit audio mode;
Recorded in LP mode;
Blank, or contains a blank portion in the middle.
When
INPUT SELECT
is set to DV IN.
If the time display on this unit is set to tape counter mode
during editing, this unit stops the editing operation
automatically when the counter reaches “0:00.00”.
In order to ensure that the editing operation is performed
properly, the editing points should be set at least 20
seconds after the beginning of the tape.
When using the editing controller for remote control:
In order to conserve battery power, JOG/SHUTTLE turns
off after one minute.
If JOG/SHUTTLE turns off after the edit start point has
been set on the recording unit (step 2), it is necessary to
press JOG/SHUTTLE again (so that it is lit) before
searching for the edit start point on the playback unit.
If JOG/SHUTTLE turns off after the edit start point has
been determined on the playback unit (step 4), it is
necessary to press JOG/SHUTTLE twice in order to start
editing.
39