Filter
Top Products
13
JOG/SHUTTLE Indicator
While this display is lit, the unit is set to the Jog/Shuttle
mode.
Check that the display is lit before proceeding with a
jog or shuttle operation.
The display is automatically turned off if no operation
is performed.
14
VIDEO INSERT Indicator
This indicator is lit when the video insert editing is
performed.
24 REC
To start recording.
25 AUDIO REC LEVEL
15
AUDIO DUB Indicator
This indicator is lit when the Audio Dubbing or Audio
Mixing is performed.
16
AUDIO INSERT Indicator
This indicator is lit when the audio insert editing is
performed.
26
S-VIDEO IN (AV2)
17
18
Cassette Tray
Indicators for AUDIO MONITOR
The audio track selected by
STEREO SELECT
lights.
(This applies only to a tape recorded in the 12 bit audio
mode.)
27 VIDEO IN (AV2)
28
AUDIO IN (AV2)
19
MIXING EDIT
To connect the audio cable to a movie camera or to
For Mixing Editing.
another VCR.
20
INPUT SELECT
29
To select the A1, A2 or DV IN external recording source.
21
SP/LP
To select the desired tape speed for recording.
30
DV IN/OUT Indicators
22
AUDIO OUT
To select the desired sound mode.
When this button is pressed, the audio output mode
changes as follows.
Stereo
Left
Right
The Left(L) and Right(R) Indicators shown which sound
mode is selected in the following way.
Stereo:
Both the L and R Indicators appear.
Left:
The L Indicator appears.
Right:
The R Indicator appears.
31
Display
32
23
STEREO SELECT
To select the audio track (STEREO1 audio and/or
STEREO2 audio) on a tape which was recorded in the
12bit audio mode. During playback, each time the button
is pressed, the sound changes as follows:
STEREO1
STEREO2
STEREO1
STEREO2
(MIX)
The audio track cannot be selected during the
playback of a tape recorded in the 16bit audio mode.
When INPUT SELECT is set to DV IN and a 12bit
audio mode input signal is being received, the audio
track can be selected by STEREO SELECT at any
time.
To adjust the audio recording level to peak at +4 dB on
the recording level indicator.
When INPUT SELECT is set to DV IN the audio
recording level cannot be adjusted.
To connect the S-Video cable to a movie camera or to
another VCR that has an S-Video output socket.
If an S-Video cable is connected, other video input
(AV2) is automatically switched off.
To connect the video cable to a movie camera or to
another VCR.
EDITING CONTROLLER Socket
When using the editing controller separate from the main
unit, remove the modular cap and then connect the
editing controller cable.
DV IN:
DV OUT:
This indicator is lit when INPUT SELECT is
set to “DV IN”.
This indicator is lit when a playback operation
is performed using this VCR or when INPUT
SELECT
is set to other than “DV IN”.
Indicators for AUDIO DATA
Displays the audio data that is to be recorded, or the
audio data on a tape that has already been recorded.
The audio recording mode can be set in the SET UP
MENU.
12bit-STEREO1 : To play back a tape that is recorded in
12bit audio mode.
12bit-STERE02: To play back a STEREO2 audio tape
recorded in the 12bit audio mode.
16bit :
To play back a tape that is recorded in
16bit audio mode.
5