Filter
Top Products
Infra-red Remote Controller
5
STEREO SELECT
6
MENU
To make the On Screen Display Main menu appear on
7
the monitor screen.
POWER
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still connected to the
mains.
To make selections from the On Screen Display.
8
OK
REC
To confirm the selection, or to store.
To start recording.
Press both buttons at the same time.
AUDIO OUT
To select the desired sound mode.
When this button is pressed, the audio output mode
SP/LP
To select the desired tape speed for recording.
changes as follows.
Stereo
Left
Right
9
10 INPUT SELECT
To select the Al, A2 or DV IN external recording source.
11
(PLAY)
To start playback.
is lit during playback.
The Left(L) and Right(R) Indicators shown which sound
mode is selected in the following way.
Stereo:
Both the L and R Indicators appear.
Left:
The L Indicator appears.
Right:
The R Indicator appears.
To select the audio track (STEREO1 audio and/or
STEREO2 audio) on a tape which was recorded in the
12bit audio mode. During playback, each time the button
is pressed, the sound changes as follows:
STEREO1
STEREO2
STEREO1
STEREO2
(MIX)
The audio track cannot be selected during the
playback of a tape recorded in the 16bit audio mode.
When INPUT SELECT is set to DV IN and a 12bit
audio mode input signal is being received, the audio
track can be selected by STEREO SELECT at any
time.
VCR1/2/3
While holding down
POWER
press one of these
buttons to select the remote control
mode.
VCR1 :
Set this position on both the VCR and
remote controller for normal use with one
VCR.
VCR2:
Set this position when using two
Panasonic VCRs.
VCR3:
Set this position when using three
Panasonic VCRs.
When the VCR’s remote control mode has been
switched, select the same remote control mode on the
editing controller as well.
1
2
3
4
7