Filter
Top Products
Program Assemble
This function can be used to link together desired scenes on a tape.
This function can also be used to skip unnecessary scenes recorded on a tape and copy them onto a separate tape.
Preparations
Complete necessary connections and settings.
See pages 24-33.
Operations
Press
EDIT MENU.
On Screen Display
Select Program Editing, and then
Press
OK.
Select Assemble, and then Press OK.
Notes:
Program Editing can be performed using either the tape
counter or Time code display, but the Time code display
should be used if the units are connected only by a DV cable.
If you attempt to switch to the tape counter display in order to
perform editing after setting the editing points using the Time
code display, the Erase all programs screen is displayed.
(The Erase all programs screen is also displayed when you
change from the tape counter display to the Time code
display.)
After setting a program, if you attempt to set another
program in a different editing operation, the set contents for
the previous editing operation remain on the setting screen.
In order to prevent editing errors, perform the Erase all
programs operation (page 61) whenever you set a program
under a different editing mode.
Program editing can not be performed with a movie camera
that has a 4-digit counter.
48