Filter
Top Products
Press RECORDER and JOG/
SHUTTLE.
The picture from the recording VCR appears on the
screen.
Search for the edit start point on the
recording VCR.
Select Start Dubbing.
Press
OK.
Editing begins.
Press EDIT MENU to stop editing.
Operation now returns to the screen which appears
in step 3. This makes it possible to continue with
editing or change the point at which editing is to
start.
Press
EXIT.
The On Screen Display disappears.
To monitor the edited audio after Audio
Dubbing
Press
STEREO SELECT
during playback and select
STEREO2.
Notes:
Audio Dubbing is not possible in the following cases:
When the tape in the recording VCR (this unit) is:
Recorded in 16bit audio mode:
Recorded in LP mode;
Blank, or contains a blank portion in the middle.
When
INPUT SELECT
is set to DV IN.
In order to ensure that the editing operation is performed
properly, the editing points should be set at least 20 seconds
after the beginning of the tape.
The pause operation may be indicated on the display of the
playback unit even though the playback unit is actually
playing the tape in slow motion.
Up to ±1 second of slight deviation in the specified edit start
position can be corrected. See page 64 for Edit Timing
Adjustment.
47