Filter
Top Products
– 15 –
Controls and their functions
<Front Panel Bottom Section>
ee
ee
e SET button
When this is pressed, the data which has been set on the setup menu is entered. After
data entry, the setup menu setting mode is exited and the original operating mode is
restored.
ff
ff
f DIAG button
When this is pressed, VTR information is displayed on-screen. When it is pressed again,
the original display is restored.
There are two types of VTR information: “HOURS METER” information and “WARNING”
information. Switching between these types is enabled by pressing the search button.
Indicated on the “HOURS METER” screen are the power-on time, drum rotation time, tape
travel time, loading count and power ON/OFF time, etc.
Indicated on the “WARNING” screen are the warning.
g
MODE/SEL button
This is used to initiate a MULTI CUE operation or other expansion mode operation. For
details, refer to page 47.
h EXIT button
This is used to exit from the MULTI CUE operation or other expansion mode operation and
return to the original mode.