Filter
Top Products
– 62 –
Setup menus
Lock mode can be set to protect the settings in the system files and user files (USER2 –
USER5). Settings can no longer be changed when this mode is set.
To set and release the lock mode for the system files and user files use setup item No. 30
(MENU LOCK) and setup menu item No. A03 (MENU LOCK), respectively.
Setting and releasing the lock mode.
1
Press the MENU button.
2
While holding down the STAND BY button, press the REW or FF button, and select the
file for which the lock mode is to be set or released.
3
Turn the search dial and move the cursor (¢) on the menu screen to setup item No. 30
(MENU LOCK) or setup menu item No. A03 (MENU LOCK) for the system or user file.
4
While holding down the search button, turn the search dial and select lock mode setting
or release.
To set the lock: Select the 0001 (ON) setting.
To release the lock: Select the 0000 (OFF) setting.
When the lock has been set, “LOCKED” flashes on the menu screen.
SETUP-MENU LOCKED
<USER2> No.800 – 0005
¢000 P–ROLL TIME 5s
001 LOCAL ENA ST&EJ
002 TAPE TIMER ±12h
003 REMAIN SEL OFF
004 SYNCHRONIZE OFF
005 SUPER ON
006 DISPLAY SEL T&STA
007 CHARA H-POS 6
008 CHARA V-POS 23
5
Press the SET button. The setting is now stored in the memory.
<Note>
• The lock mode cannot be set for the USER1 file settings.
• Even if the RESET button is pressed, the files which has been set to the lock mode cannot
be reset to the factory settings.