Filter
Top Products
– 24 –
Operations using the front panel top controls
VTR status item table
Description of display
This indicates the recording format.
1080i: The tape is recorded using the 1080i format.
720p: The tape is recorded using the 720p format.
This displays the output reference status.
HD_59: The HD REF input signal has been selected as
the reference. The field frequency is 59.94 Hz.
HD_60: The HD REF input signal has been selected as
the reference. The field frequency is 60 Hz.
IN_59: The HD serial input signal has been selected
as the reference. The field frequency is 59.94
Hz.
IN_60: The HD serial input signal has been selected
as the reference. The field frequency is 60 Hz.
INT59: The signal from the internal generator (59.94
Hz) is selected as the reference.
INT60: The signal from the internal generator (60 Hz)
is selected as the reference.
INTSC59: The SD REF input signal has been selected as
the reference. The field frequency is 59.94 Hz.
INT59N: SD REF has been selected by the OUT REF
setting. Since the SD REF signal is not input,
the signal from the internal generator (59.94
Hz) is used.
This indicates the field frequency at which the recording
was made on the tape as ascertained from the tape’s
playback signals.
59.94: The tape has been recorded at a field fre-
quency of 59.94 Hz.
60: The tape has been recorded with at a field fre-
quency of 60 Hz.
This indicates the field frequency at which the recording
is to be made on the tape.
59.94: The recording will be made on the tape at a
field frequency of 59.94 Hz.
60: The recording will be made on the tape at a
field frequency of 60 Hz.
This indicates the format of the HD serial output.
1080i: The HD serial output uses the 1080i format.
720P: The HD serial output uses the 720p format.
NONE: Output is in a state of mute according to the
setting of the setup menu No. 626 - No. 630.
This indicates the format of the SD output.
480i: The SD output is in the 480i format.
480P: The SD output is in the 480p format.
NONE: Output is in a state of mute according to the
setting of the setup menu No. 626 - No. 630.
This indicates the status of HD-SD format converter
board (AJ-UDC150AP, sold separately).
LN_CON: The line converter is operating.
UP_CON: The up-converter is operating.
DW_CON:
The down-converter is operating.
NONE: HD-SD format converter board (AJ-
UDC150AP, sold separately) is not installed.
REC FORMAT
REF OUT
PB FLD RATE
REC FLD
RATE
HD OUT
SD OUT
UFC
000
001
002
003
004
005
006
I
tem as it ap-
pears on VTR
status display
REC FMT
REFOUT
PB_FLD
RECFLD
HD_OUT
SD_OUT
UFC
Name of registration
menu item