Panasonic AJ-HD150FE VCR User Manual


 
– 68 –
Setup menus
USER menu
<BASIC>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
000 P-ROLL 0000 0S
TIME : :
0005 5S
::
0015 15S
001 LOCAL 0000 DIS
ENA
0001 ST&EJ
0002 ENA
002 TAPE 0000 ±12h
TIMER 0001 24h
003 REMAIN 0000 OFF
SEL 0001 ON
004 SYNCHRO- 0000 OFF
NIZE 0001 ON
005 SUPER 0000 OFF
0001 ON
0002 SW
The underline on the setting item denotes the initial setting.
This sets the preroll time which can be set from 0 to 15
seconds in 1-second increments.
<Note>
When the unit is set to automatic editing [PREVIEW, AUTO
EDIT], the unit will not operate if the preroll time is set to 0
seconds.
This selects the buttons which can be operated on the front panel
when the REMOTE/LOCAL switch has been set to REMOTE.
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All buttons except for the RECORDER and PLAYER
buttons can be operated.
This selects the 12 or 24 hour display for the CTL counter.
0: 12 hour display
1: 24 hour display
This selects whether the REMAIN (remaining tape time)
display is to be superimposed onto the HD SDI OUT3, SD SDI
OUT3 and VIDEO OUT3 connector signals.
0: Display is not superimposed.
1: Display is superimposed.
<Note>
1. Even when “1: ON” is selected, the remaining tape time will
not be displayed while this is being calculated after a tape
has been ejected or inserted.
2. The remaining tape time is not displayed when TIME has
been selected as the setup menu item No.006 (DISPLAY
SEL) setting.
This sets whether the phase is to be synchronized between
two decks.
0: The phase is not synchronized. The edit points will be off
by several frames but editing can be entered more quickly.
1: The phase is synchronized. Error-free editing can be
performed.
This selects whether the time code and other displays are to
be superimposed onto the HD SDI OUT3, SD SDI OUT3 and
VIDEO OUT3 connector signals.
0: Displays are not superimposed.
1: Displays are superimposed.
2: Pressing PLAY button after pressing SET button (front
panel bottom e ) selects the super display ON/OFF.
<Note>
Pressing SET button after pressing PLAY button results in
same operation as in normal PLAY button pressing.