Filter
Top Products
62
RQTV0134
Troubleshooting guide
Operation Page
Cannot operate the TV. ≥Change manufacturer code. Some TVs cannot be operated even if you change the code.
≥Press [TV/VIDEO] to change the input mode to “TV”.
19
26
Cannot operate the DVD. ≥Press [DRIVE SELECT] to select DVD drive when operating DVD. 11
Cannot operate the VHS. ≥Press [DRIVE SELECT] to select VHS drive when operating VHS. 11
The remote control doesn’t
work.
≥The remote control code is wrong. Change to the correct code.
≥The batteries are depleted. Replace them with new ones.
≥Point the remote control at the remote control sensor on the main unit.
≥Remove obstacles between the remote control and main unit.
≥Colored glass may abstruct the signal reception/transmission.
≥Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight exposure.
≥It may be necessary to set the code on the remote control again after changing the batteries.
≥It may be necessary to set the manufacturer code again after changing the batteries.
19
9
9
–
–
–
9
9
The unit is on but cannot be
operated.
≥Some operations are prohibited by the disc.
≥The unit is warm (“U59” appears on the unit’s display). Wait until “U59” disappears.
≥One of the unit’s safety devices may have been activated.
Reset the unit as follows:
(1) Press [Í/I, POWER] on the main unit to switch to standby.
If the unit doesn’t switch to standby, press and hold [Í/I, POWER] on the main unit for about 10
seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC power supply cord, wait for about 1 minute, then reconnect it.
(2) Press [Í/I, POWER] on the main unit to turn the unit on.
–
–
–
Cannot eject a disc. ≥The unit is recording
≥The unit may have a problem. While the unit is off, hold down [∫] and [CH, W] on the main unit
simultaneously for about 5 seconds. Remove the disc and consult the dealer.
–
–
Startup is slow ≥Make sure that “Quick Start” is set to “On”.
Even if “Quick Start” is set to “On”, startup is slow if the clock is not set, there was a power failure or
the AC plug has just been connected.
≥A few dozen seconds after turning on the unit, you can play a disc or start recording to discs other
than DVD-RAM.
56
–
Takes time to read DVD-RAM ≥It may take time to read a disc if it is being used for the first time in this unit or it has not been used
for a long time.
–
M6VP&PC.book 62 ページ ２００６年２月６日 月曜日 午後３時２０分